Wayne-Dalton 341785 Benutzerhandbuch

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. 

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at 

Tools Needed:

Ratchet Wrench

1/2” socket

1/2” Wrench

(2) Vice Clamps

level

hammer

Tape Measure

kEEP hORIzONTal TRaCk 

PaRallEl aND WIThIN 3/4” 

MaxIMuM OF DOOR EDGE, 

OThERWIsE DOOR COulD Fall, 

REsulTING IN sEVERE INjuRy OR 

DEaTh.

Raise the door until the top section 
and half of the next section are in a 
horizontal position. Do not raise door 
any further since the horizontal track 
are not yet supported at the rear.

RaIsING DOOR FuRThER CaN 

REsulT IN DOOR FallING aND 

CausE sEVERE INjuRy OR 

DEaTh.

Clamp a pair of vice clamps on the 
vertical tracks just above the second 
roller on one side, just below the second 
roller on the other side. This will prevent 
the door from raising or lowering while 
installing the rear support. 

using perforated angle,
5/16” x 1-5/8”hex head lag screws 
and 5/16” bolts with nuts (may not 
be supplied), fabricate rear support 
for horizontal tracks. attach horizontal 
tracks to the rear supports with
5/16”-18 x 1-1/4” hex bolts and nuts 
(may not be supplied). horizontal tracks 
must be level and parallel with door. 

NOTE: If rear supports are to be 
installed over drywall, use 5/16” x 2” 
hex head lag screws.

adjust weather seal or door stop (if 
necessary). Now permanently attach 
the weather seal or door stop to both 
door jambs and header. (They were 
temporarily attached in PREPaRING ThE 
OPENING on page 10.) avoid pushing 
weather seal or door stop too tightly 
against face of door.

PRIOR TO WINDING OR MakING 

DOOR IN PaRTIally 

OPEN  POsITION

VERTICal

TRaCk

VICE 

ClaMPs

3/4”

DOOR EDGE

hORIzONTal 

TRaCk