Wayne-Dalton 341785 Benutzerhandbuch

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. 

To find your Wayne-Dalton dealer; refer to your local yellow pages / business listings or go to Find a dealer area online at 

Tools Needed:

Tools Needed:

Install the side lock on the second 
section of the door. secure the lock to 
the section with (4) 1/4”- 20 x 11/16” 
self drilling screws. square the lock 
assembly with the door section and 
align with the square hole in the vertical 
track. The side lock should be spaced 
in approximately 1/8” from the section 
edge.

IMPORTANT: sIDE lOCks MusT bE 

REMOVED OR MaDE INOPERaTIVE IN 

ThE uNlOCkED POsITION, IF aN 

OPERaTOR Is INsTallED ON ThE 

DOOR.

NOTE: after completing this step, 

continue with step 9 on page 17.

Power Drill

7/16” socket 

Driver

Tape Measure

DO NOT INsTall Pull ROPEs 

ON DOORs WITh ElECTRIC 

OPERaTORs. ChIlDREN May 

bECOME ENTaNGlED IN ThE 

ROPE CausING sEVERE OR 

FaTal INjuRy.

Measure and mark the jamb 
approximately 48” to 50” (1220 to 1270 
mm) from floor on the right or left side 
of jamb. Drill 1/8” pilot hole for No. 6 
screw eye.  Tie the pull rope to the No. 
6 screw eye and to the bottom bracket 
as shown.

NO. 6 sCEW EyE

Pull ROPE

bOTTOM bRaCkET

Pull ROPE

Power Drill

1/8” Drill bit

(4) 1/4”- 20 x 11/16” 

sElF DRIllING sCREWs

1/8”