Vacmaster Vacuum Cleaner VHB307WM Benutzerhandbuch

 
 

6 

 

 

 
 
A Philips head screwdriver is required.   

 

 

 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY 
1.  Verify that the power cord is disconnected from the outlet.  (fig.1) 
2.  Undo the latches.  (fig.2)  
3.  Lift the power head off the collection tank.  (fig.3)  
4.  Remove the contents from inside the collection tank, make sure you have all contents as listed on page 5.  

 (fig.4) 

5.  For dry vacuum cleaning, install the supplied reusable cloth filter.  (fig.5) See page 10 for filter installation. 
6.  Optional, for improved dust filtration, fit collection bag onto the tank.  Fit the flange onto the inlet stub,  

taking care not to damage the bag.  (fig.6) 

7.  For wet vacuum cleaning, install the supplied foam filter. (fig.7) See page 10 for filter installation. 
8.  Insert the casters and wheels into the respective sockets on the bottom of the base.  Apply pressure until 

castors and wheels snap into place.  (fig.8) 

9.  Turn the collection tank upside down and fit the base assembly onto the tank.  Secure the base to the 

tank with the supplied screws. Verify that the base is assembled correctly.  Do not over-tighten screw. 
(fig.9)  

10.  Place the power head back on the collection tank, aligning the top section with the latches, and snap 

into place.  (fig.10 & 11) 

11.  Insert the larger end of the hose into the desired port.  (fig.12) 
12.  Choose the desired accessories and insert onto the end of the hose.  (fig.13) 
For your convenience this vacuum comes with a wall mounting support for storage. 

•  Do not mount the rack over 5 feet from the floor. 

•  Do not screw the rack to drywall only.  Secure the screws to a stud.