Vacmaster Vacuum Cleaner VHB307WM Benutzerhandbuch

 
 

7 

 

•   Do not hang from or sit on the vacuum when on mounting rack. 
13.  Align the two screw holes so that they are over a stud and secure the mounting support to the wall stud,   
       as shown, with the two screws provided.  (fig.14)  
14.  Place the wet and dry vacuum cleaner into the support.  (fig.15) 

 

POLARIZED PLUG 
To reduce the risk of electrical shock, this appliance has a double polarized plug (one with the blade wider 
than the other).  This plug will fit in a polarized outlet only one way.  If the plug does not fit fully in the outlet, 
reverse the plug.  If it still does not fit, contact a qualified electrician to install the proper outlet.  Do not 
change the plug in any way.  Double insulation           eliminates the need for the three wire grounded power 
cord and grounded power supply system. 
 
 
 

INSTRUCTIONS & WARNINGS’.  DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, 
OR EXPLOSIVE DUSTS IN THE AIR.  FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT 
LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, 
ALCOHOL OR AEROSOL SPRAYS.  EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO; 
COAL, MAGNESIUM, GRAIN OR GUN POWDER.  TO REDUCE THE RISK OF HEALTH HAZARDS 
FROM VAPORS OR DUST, DO NOT VACUUM TOXIC MATERIALS. 

 

1.  Verify that the power cord is disconnected from the outlet.  (fig.1) 
2.  In order to prepare your vacuum for dry vacuuming, make sure the filter is completely covering the filter  

cage against the power head. (fig.2 & 3)(Your Wet/Dry Vac comes with the reusable cloth filter pre- 
installed, if not, see page 10 for installation instructions.) 

3.  Place the dust bag to the vacuum port inside the tank, and press to make sure the dust bag is well 

assembled. (fig.4) 

4.  Place the power head section back on the collection tank, and secure it in place using the latches.  (fig.5) 

 

 

5.  Insert the larger end of the hose into the vacuum port on the tank. Push the required attachment onto  
     the free end of the hose or extension.  (fig.6)  
6.  Plug in the power cord into the outlet.  (fig.7) 
7.  Turn the motor on by flipping the switch to the ‘I’ ON position and begin vacuuming.  (fig.8) 
8.  Once you have completed vacuuming, flip the switch to the ‘O’ OFF position and unplug the power cord  
     from the outlet.   

O = OFF       I = ON