Fluke Lawn Mower 2635A Benutzerhandbuch

Setup File Procedures

3

3-11

Perform the procedure in Figure 3-7 to remove a setup file from the memory card.
Removing a file does not interrupt the sequential SEtxx file names assigned with the
SEtUP STORE command. When SEt99 is reached, the instrument loops back to reuse
previously assigned file names that have been erased or skipped over. To exit at any time
(file not erased), press the 

C key.

SEt99
SEtxx
SEt00

Selecting the SETUP mode.  Press the FILES 
key to access the FILES menu.  Press the 
up/down arrow keys until SEtUP is displayed, 
then press the ENTER key.  The menu changes 
to SEtUP.  If an error message appears, see 
Table 3-1.

Selecting the ERASE mode.  Press the 
up/down arrow keys until ErASE is displayed in 
the SEtUP menu, then press the ENTER key.  
The menu changes to ErASE.

Selecting a SEtxx File to ERASE.  Press the 
up/down arrow keys until the SEtxx file to be 
erased is displayed in the ErASE menu, where xx 
represents a number from 00 to 99, then press 
the ENTER key.  The menu changes to SUrE.

Typical

Required

yES
no

Erasing a SEtxx File.  Press the up/down arrow 
keys to select yES or no in the SUrE menu, then 
press the ENTER key.  yES will erase the file, no 
will cancel the procedure and nothing will be 
erased.  The procedure repeats after pressing 
ENTER, or displays nonE if there are no files to 

erase. Press the CANCL key to exit.  If an error 
message occurs, see Table 3-1.

Init
StAt
dir
dAtA
SEtUP

ErASE
StorE
LOAd

op43f.eps