Vanguard Managed Solutions Vanguard 342 Benutzerhandbuch
Installation and Replacement
3-9
Configuring the Serial Interface
Setting the Interface Type
Introduction
This section provides instructions for setting the Interface Type parameter.
Interface Type
Parameter
Parameter
Use this procedure to set the Interface Type parameter:
Step
Action
Result/Description
1
From the Control Terminal
Port Main menu, select
Configure -> Port.
Port Main menu, select
Configure -> Port.
The Port record appears.
2
In the Port Number parameter,
type 3, then press ENTER.
type 3, then press ENTER.
Port 3 is selected.
3
In the Port Type parameter,
type FRI, then press ENTER
type FRI, then press ENTER
This defines Port 3 type as FRI.
4
In the Interfaced Type, type a
?, and then press ENTER.
?, and then press ENTER.
The Range and Default appear:
Range = V.24, V.35, V.36, X.21, NONE
Default = V.24
Specify the Electrical Interface Type:
V.24 - V.24 Electrical Interface Type
V.35 - V.35 Electrical Interface Type
V.36 - V.36 Electrical Interface Type
X.21 - V.11 Electrical Interface
Type
Type
NONE - Electrically disabled
5
Select an Interface Type from
the menu and press ENTER.
the menu and press ENTER.
The Interface Type is set.