Omron CompoBus/D (DeviceNet) Communications Card 3G3FV-PDRT1-SIN Benutzerhandbuch

Malfunctions in CompoBus/D communications that are a result of broken wires, short circuits, reversed
wiring, duplicate node address assignments, or noise interference are detected as transmission (BUS)
errors. When a transmission error is detected, the Inverter’s Fault Bit will turn ON and the motor will
coast to a stop. (For Inverters with a software version of 1042 or later, the operation when a communica-
tions error occurs can be set using constant F9-06.)

When an error is detected, perform error processing according to the indicator display of the Compo-
Bus/D Communications Card.

H

The CompoBus/D Communications Card has 4 operation indicators that show the status of the power
and communications.

PWR

Green Lit

Power is being supplied from the Inverter
to the Card.

---

---

Not lit

Power is not being supplied from the In-
verter.

The Card is not connected properly and
power is not being supplied to it.

Check the Option Card con-
nector and turn ON the Invert-
er power supply.

Replace the Option Card.

MS

Green Lit

The Card is operating normally.

---

Flashing

Initial settings or necessary preparations
for communications are incomplete.

Turn ON the Inverter power
supply again.

Replace the Option Card.

Red

Lit

A fatal error (hardware error) has occurred
in the Card.

Turn ON the Inverter power
supply again.

Replace the Option Card.

Flashing

A non-fatal error, such as a switch setting
error, has occurred.

Check the baud rate setting.

Turn ON the Inverter power
supply again.

Replace the Option Card.

---

Not lit

Power is not being supplied from the In-
verter.

The Card is not connected properly and
power is not being to supplied to it.

Check the Option Card con-
nector and turn ON the Invert-
er power supply.

Replace the Option Card.