FieldServer FS-8700-72 Benutzerhandbuch
FS-8700-72 Secutron Manual
Page 5 of 15
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll Free: 888-509-1970 email: support@fieldserver.com
4.
Configuring the FieldServer as a Secutron Modul-R driver Client
For a detailed discussion on FieldServer configuration, please refer to the FieldServer Configuration
Manual. The information that follows describes how to expand upon the factory defaults provided in the
configuration files included with the FieldServer (See “.csv” files on the provided with the FieldServer).
This section documents and describes the parameters necessary for configuring the FieldServer to
communicate with Secutron Modul-R panels.
The configuration file tells the FieldServer about its interfaces, and the routing of data required. In order
to enable the FieldServer for Secutron Modul-R driver communications, the driver independent
FieldServer buffers need to be declared in the “Data Arrays” section, the destination device addresses
need to be declared in the “Client Side Nodes” section, and the data required from the Servers needs to
be mapped in the “Client Side Map Descriptors” section. Details on how to do this can be found below.
Note that in the tables, * indicates an optional parameter, with the bold legal value being the default.
Manual. The information that follows describes how to expand upon the factory defaults provided in the
configuration files included with the FieldServer (See “.csv” files on the provided with the FieldServer).
This section documents and describes the parameters necessary for configuring the FieldServer to
communicate with Secutron Modul-R panels.
The configuration file tells the FieldServer about its interfaces, and the routing of data required. In order
to enable the FieldServer for Secutron Modul-R driver communications, the driver independent
FieldServer buffers need to be declared in the “Data Arrays” section, the destination device addresses
need to be declared in the “Client Side Nodes” section, and the data required from the Servers needs to
be mapped in the “Client Side Map Descriptors” section. Details on how to do this can be found below.
Note that in the tables, * indicates an optional parameter, with the bold legal value being the default.
4.1.
Data Arrays/Descriptors
Section Title
Data_Arrays
Column Title
Function
Legal Values
Data_Array_Name
Provide name for Data Array
Up
to
15
alphanumeric
characters
characters
Data_Format
Provide data format. Each Data Array can only take
on one format.
on one format.
Bit, Byte, Packed_Bit,
Uint16
Uint16
Data_Array_Length
Number of Data Objects. Must be larger than the data
storage area required for the data being placed in this
array.
storage area required for the data being placed in this
array.
1-10,000
Example
// Data Arrays
Data_Arrays
Data_Array_Name,
Data_Array_Format,
Data_Array_Length
p1c1_devices,
Bit,
1
p1c1_function,
Byte,
1000
p1c69_restart,
Bit,
1000
p1c69_function,
Byte,
100
p1c90_reset,
Bit,
100
p1c90_function,
Byte,
100
The Poller Data Array will contain non-zero data when communications with the panel is OK.