Allstar Products Group Twist'R Plus Class I Vehicular Swing Gate Operator Benutzerhandbuch
9
106504
Figure 8A: Service Conduits
TOOLS and MATERIALS REQUIRED
The following tools and materials are required for a proper installation of the Twist'R Plus Model RS4000.
1. Wire cutter, stripper and crimping tools for attaching accessory equipment to the control box.
2. #2 Phillips Head screw driver for general use.
3. Medium standard straight blade screw driver for the terminal strip screws.
4. Very small blade screwdriver for adjusting the potentiometer on the gate control board.
5. Electric arc welder or an electric drill with a 3/8" bit for attaching Arm Bracket to the Gate.
6. Several feet of #18 or #22 gauge insulated multistrand wire for connecting accessory equipment to the control panel.
7. Four 1/2" diameter concrete "redhead" anchor bolts with hex nuts, flat washers and lock washers for attaching the Twist'R pedestal. (Not
1. Wire cutter, stripper and crimping tools for attaching accessory equipment to the control box.
2. #2 Phillips Head screw driver for general use.
3. Medium standard straight blade screw driver for the terminal strip screws.
4. Very small blade screwdriver for adjusting the potentiometer on the gate control board.
5. Electric arc welder or an electric drill with a 3/8" bit for attaching Arm Bracket to the Gate.
6. Several feet of #18 or #22 gauge insulated multistrand wire for connecting accessory equipment to the control panel.
7. Four 1/2" diameter concrete "redhead" anchor bolts with hex nuts, flat washers and lock washers for attaching the Twist'R pedestal. (Not
Included)
8. Concrete drill and bit to drill mounting holes for concrete bolts.
9. Multimeter to test line voltage and other measurements as necessary.
10. Small level to level the RS4000 operator at installation.
11. Torque Wrench and 1/2” Socket.
12. 7/16 Socket or Wrench to remove cover bolts.
9. Multimeter to test line voltage and other measurements as necessary.
10. Small level to level the RS4000 operator at installation.
11. Torque Wrench and 1/2” Socket.
12. 7/16 Socket or Wrench to remove cover bolts.
UNPACKING CHECKLIST
The Twist'R Plus as shipped consists of the components listed below, in two separate shipping boxes. The kits and equipment listed in
the Optional Column can be purchased from your dealer.
the Optional Column can be purchased from your dealer.
BOX #1
•
Twist’R Plus Operator, complete with
gate control board
gate control board
•
Hardware Installation Kit, for
pedestal kit or standard 4 x 4 tube
mount
pedestal kit or standard 4 x 4 tube
mount
•
Instruction Kit, with manual, warranty
and warning signs.
and warning signs.
BOX #2
•
Swing Arm Kit
Swing Arm
Crank Arm
Crank Arm Extension
Swing Gate Fittings
Swing Arm Bracket
Swing Arm Padlock
Crank Arm
Crank Arm Extension
Swing Gate Fittings
Swing Arm Bracket
Swing Arm Padlock
•
Hardware Package
OPTIONAL
•
Pedestal Kit
•
Allstar Radios
•
Electric Edges
•
Photoelectric Eyes
•
Vehicle Detector Loops
C:
INSTALLING THE OPERATOR
B:
PREPARING THE SITE