Dacor DR30DHLP Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PG05-006

Revised 01/30/13   Page 3/6

Note 3

Note 6

E

F

3

Cabinet/countertop depth is at discretion of customer but

cabinet face MUST NOT protrude further than rear of

cabinet front, see Product Dimensions.

4

Consult local code for exact location requirements.

6

Model DR30D[H]: 37 7/8 (96.2 cm) max.

Model DR30DI[H]: 37 7/16 (95.1 cm) max.

2

Distance to combustible surfaces measured from cooking

surface (top of cooktop grate); if installing an overhead

range hood, also check the hood specifications for minimum

required clearances.

1

Minimum distance to a combustible rear wall for model

DR30DI[H] is 2.5” (6.4 cm) from top rear trim. Model DR30D[H]

may be installed flush to rear wall, but non-combusible surface

or 9-inch backguard (PNADB3009) is recommended.

Back wall

1

10” (25.4 cm) min.

to combustible side

walls above the range

(both sides)

30” (76.2 cm)

min.

2

13” (33.0 cm)

max.

5

18” (45.7 cm)

min.

2, 5

Suggested

location of

utilities

4

5

This specification does not apply for cabinets located

greater than a horizontal distance of 10” (25.4 cm)

from the edge of the range.

36” (91.4 cm)*

30” (76.2 cm)**

30 

1

/

16

” (91.6 cm)

* Recommended     ** Minimum

*** See following page for model DR30DI[H]

 

■

The shaded area shown below denotes the location of the gas inlet 

and the electrical junction box/receptacle. This is the recommended 

location. For replacement purposes, the location of the existing 

utilities may be utilized provided they do not interfere with the sides 

or rear of the range. Check local building codes for permissible gas 

valve locations.

 

■

An external manual shut-off valve must be installed between the gas 

inlet and the range for the purpose of turning on or shutting off gas to 

the appliance.

 

■

Access to the gas shut-off valve when the unit is installed. 

 

■

Access to the remote circuit breaker panel/fuse box when the range 

is in place.  

 

■

The gas supply piping, gas shut-off valve and the electrical junction 

box or receptacle must be located so they do not interfere with the 

range when it is installed.

 

■

The junction box and gas shut off valve must be located so that 

the range can be pulled out for service while the appliance remains 

connected. 

 

■

Carefully check the location where the range is to be installed. For 

best performance, the range should be placed away from drafts that 

may be caused by doors, windows and heating and air conditioning 

outlets.

 

■

To reduce the risk of personal injury and to reduce accumulated 

smoke in the room, Dacor strongly recommends installing a range 

hood or raised vent (model DR30DI[H] only). A range hood should 

project horizontally a minimum of five (5) inches beyond the face of 

the cabinets.

 

■

All maximum and minimum dimensions and clearances shown in the 

diagram below must be maintained for safe operation.

 

■

Any openings in the wall behind the appliance or in the floor 

underneath it must be sealed. 

 

■

Carefully note the requirements stated below for clearances to walls 

and cabinets.

Cabinet tolerances: -1/16”, (+1.6 mm) -0