Maytag MDE18PDAYW Installationsanweisungen

22

3.  Connect remaining wires under outer terminal block screws (F). 

Tighten screws.

4.  Connect a separate copper ground wire (G) under the green 

external ground conductor screw (C) to an adequate ground. 

Finally, reinstall terminal block to dryer rear panel. Secure cover 

with hold-down screw.

Use for direct wire or power supply cord where local codes  

do not permit connecting cabinet-ground conductor to neutral 

wire.

Connecting Neutral Wire
1.  Remove center terminal block screw (A). Also remove neutral 

ground wire (B) by removing green external ground conductor 

screw (C).

2.  Connect neutral ground wire (B) and neutral wire (white or 

center wire) (D) of power supply cord/cable under center 

terminal block screw (A). Tighten screw.

Connecting 3-Wire Connection: Optional

1.  Remove cardboard from beneath dryer. Place a level on top 

edges of dryer, checking each side and front. If not level, tip 

dryer and adjust legs up or down as shown in Step 3, repeating 

as necessary. 

Leveling your dryer properly reduces excess noise and vibration.

Not Level

LEVEL

Not Level

(appearance may vary)

A

B

A

B

D

C

G

C

F

F