Maytag MDE18PDAYW Installationsanweisungen

24

9.  Attach door hinges to dryer door so that larger hole is at the 

bottom of the hinge and the hinge pin is toward the door front.

10.  Remove the 4 screws that attach 2 plugs on the left side. 

Attach plugs to right side using the same 4 screws.

11.  Insert screws into bottom holes on left side of cabinet. Tighten 

screws halfway. Position door so large end of door hinge slot 

is over screws. Slide door up so screws are in bottom of slots. 

Tighten screws. Insert and tighten top screws in hinges.

12.  Close door and check that door strike aligns with door catch.  

If needed, slide door catch left or right within slot to adjust 

alignment.

You can change your door swing from a right-side opening  
to left-side opening, if desired.

Remove the Door Assembly 

1.   Place a towel or soft cloth on top of dryer or work space to 

avoid scratching of the surface.

2.  Open dryer door. Remove bottom screws from cabinet side of 

hinges. Loosen (do not remove) top screws from cabinet side 

of hinges.

3.  Lift door until top screws in cabinet are in large part of hinge 

slot. Pull forward off screws. Set door (handle side up) on top 

of dryer. Remove top screws from cabinet.

4.   Remove screws attaching hinges to door.
5.  Remove screws at top, bottom, and side of door (5 screws). 

6.  Holding door over towel on dryer, grasp sides of outer door and 

gently lift to separate it from inner door. Do not use a putty knife 

to pry apart. Do not pull on door seal or plastic door catch.

7.  Be certain to keep cardboard spacer centered between doors. 

Reattach outer door panel to inner door panel so handle is on 

the side where hinges were just removed.

8.  Reattach screws at top, bottom, and side of door (5 screws). 

Towel

Hinges

(appearance may vary)