Blomberg DHP24412W Benutzeranleitung

10 / 28  EN

Dryer / User Manual

A

• 

The clothes dryer (“appliance‘) installation must be 

performed by a qualified installer.

• 

Install the appliance according to the 

manufacturer’s instructions and local codes.

• 

Do not install a clothes dryer with flexible plastic 

venting materials. If flexible metal (foil type) duct 

is installed, it must be of a specific type identified 

by the ap pliance manufacturer as suitable for use 

with clothes dryers. Flexible venting materials are 

known to collapse, be easily crushed, and trap lint. 

These conditions will obstruct the clothes dryer’s 

airflow and increase the risk of fire.

•   To reduce the risk of severe injury or death,           

follow all installation instructions.

Connect the appliance to a grounded outlet protected by 

a fuse or circuit breaker of suitable capacity.

 

4-wire receptacle  
(14 -30R) 
 

3-wire receptacle  
(10 -30R) 
 

If yo u have 3-wir e receptacle, like  
this , a 3-wire dryer cord  mu st be 
purc hased locall y. 

 

Dryer shipped with cord to fit this
type 4 -wire receptacle

If your receptacle is a 3-wire receptacle as shown 

below, you must obtain a 3-wire dryer cord. A dryer 

cord can usually be found at your local hardware 

supply, electrical supply or home center. Cord should 

have closed loop or upturned end wire terminating 

connectors. The cord kit must be marked “For Use with 

Clothes Dryers”. 

3- wire receptacle

( 10-30R)

Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT

A

If the dryer is installed in a mobile home, 

recreational vehicles, new branch-circuit 

installations or in areas where local 

codes do not permit grounding through 

the neutral conductor, only a 4-wire 

power supply cord shall be used.

1. Make sure that the dryer is not plugged into any 

power outlet.

B

DO NOT plug end of dryer power cord 

into a live receptacle before connecting 

dryer power cord to dryer terminals and 

closing junction/splitter box as described 

below.

B

DO NOT repair old power supply cords. 

Power cord must be changed only by a 

qualified person. There is a risk of electric 

shock!

2. Remove the screw from the cover of the junction box 

located at the top rear of the dryer.

3. Remove the red, white and black wire from the 

terminal block.

4. Remove the green ground wire from the ground 

terminal.

5. Loosen the strain relief clamp holding the 4-wire 

cable.

6. Thread the 4-wire cable out through the strain relief 

clamp.

7. Thread the new 3-wire dryer cord through the strain 

relief clamp.

8. Attach the power cord Ground conductor (the center 

wire) to the terminal labeled N. Connect the 

terminal labeled N and the Ground terminal labeled 

G. Tighten the terminals so that they securely hold 

the conductors.