Broan B5630SS Installationsanweisungen

1. Drill two 

5

⁄

16

” diameter holes where shown. Insert drywall 

anchors into the holes.

2. Center the bracket over the hood location and flush with the 

ceiling. Make sure that the slots of the upper flue bracket are 
at the bottom. Secure the upper flue bracket to the wall using 
(2) #8 x 1½” mounting screws.

3. Tighten the screws completely. Make sure that the bracket 

is tight against the wall.

L

L

1.  DO NOT REMOVE the protective plastic film covering the 

decorative flue and the hood at this time.

2.  Lay the back side of the hood flat on a table. Use a piece of 

cardboard to avoid damaging the table or the hood.

3.  Attach damper / duct connector to top of hood using (4) 

#8 x 3/8” Pan Head mounting screws.

4.  Remove the grease filters by pulling down the metal latch 

tab and tilting filters downward to remove.

5.  Carefully rotate hood upright.

HD0255A

H

OLES

 

LOCATION

Ø5/16” 

TYP

.

M

OTOR

/B

LOWER

ASSEMBLY

S

IDE

 

VIEW

I

NSIDE

 

BACK

OF

 

THE

 

HOOD

6.  Make sure there will be adequate clearance between top of 

hood and lower flue mounting bracket for ductwork. Elbow 

must be located below lower flue mounting bracket.

7.  Align the hood and center it above the hood mounting 

bracket. Gently lower the hood until it securely engages the 

bracket.

8.  With the hood hanging in place, drill through the both holes 

located in the inside lower back of hood using a 5/16” drill 

bit. Insert the included drywall anchors into the drilled holes 

(one for each hole). Install (2) washers and (2) no. 8 x 1½” 

mounting screws through the back of the hood and into the 

drywall anchors. Verify that the hood is centered and leveled. 

Tighten all screws completely.

9.  Reinstall grease filters by aligning rear filter tabs with slots 

in the hood. pull down the metal latch tab, push filter into 

position and release. Make sure filters are securely engaged 

after installation.