Maytag MGD3100DW Datenbogen

20.  To gain further access to the burner assembly the drum 

will need to be removed. Before removing drum from 
dryer the CCU & bracket assembly must be secured in 
position to side panel using the plastic hook attached to 
the main harness. This will allow the CCU assembly to 
hang in place rather than dropping down when the drum 
is removed. See Figure 16.

NOTE: Only on models with the CCU Bracket  located on 
the right side of the unit.

 

 

21.  Remove drum from dryer by first reaching into dryer just 

under the drum, to back side of drive motor. Grasp idler 
pulley and lift up to relieve tension from belt and remove 
belt from motor pulley and idler pulley. Refer to Figure 17 
for belt removal and reassembly.

 

 

 

   

22.  Remove drum from dryer by grasping the drum belt and 

front of drum and slide drum out of cabinet front. 

IMPORTANT: Note position of drum belt, front and rear 
orientation for reassembly. See Figure 18.
NOTE: When removing drum from cabinet be sure not to hit 
the CCU & bracket assembly knocking it from its hanging 
position. Continue to Step 23 “Changing the Orifice.”

 

 

5.  Remove toe panel. On some models, a small flat-head 

screwdriver is required to release the clips at the top of  
the toe panel. Continue to Step 23 “Changing the Orifice.”

5.  Lift dryer top. Use a putty knife to press against the left 

and right spring clips to release them from the top. Gently 
lean dryer top toward the wall so as not to damage the 
dryer top or wall. See Figure 1.