Maytag MGD3100DW Datenbogen
7
FIGURE 19A
(2) SCREWS
IGNITOR
BURNER
TUBE
PRESSURE
TAP PLUG
GAS VALVE
ASSEMBLY
Determine Gas Valve Style
CHANGING THE ORIFICE (BOTH STYLES)
23. Remove the two (2) screws securing the burner tube to
the burner base. See Figure 19A.
FIGURE 20
IGNITOR
BURNER
TUBE
GAS VALVE
ASSEMBLY
24. Slide burner tube forward far enough to gain access to
orifice. Do not bump ignitor. See Figure 20.
NOTE: The ignitor is fragile.
FIGURE 19B
(2) SCREWS
IGNITOR
BURNER
TUBE
PRESSURE
TAP PLUG
GAS VALVE
ASSEMBLY
NOTE: IF YOUR GAS DRYER HAS STYLE “A” FOLLOW STEP
28. FOR STYLE “B” SKIP TO STEP 29 TO 32.
28. FOR STYLE “B” SKIP TO STEP 29 TO 32.
27. Before proceeding, you must first determine which gas valve
style is on the dryer. Refer to Figure 22 - Style “A” and “B”.
FIGURE 22
STYLE “A”
TWO
SEPARATE
COILS
STYLE “B”
CAP - PERMANENTLY
FIXED TO VALVE
COVER DIAL
ONE PIECE
COIL
REGULATOR
VENT CAP
25. Remove the burner orifice from the gas valve assembly
and replace it with the proper orifice furnished in this kit.
Orifice number is stamped on one edge of the hex head
of orifice. Securely tighten. See Figure 21.
Orifice number is stamped on one edge of the hex head
of orifice. Securely tighten. See Figure 21.
Use Orifice No. 55 for Propane gas.
Use Orifice No. .049 for Butane gas.
Use Orifice No. .049 for Butane gas.
FIGURE 21
ORIFICE
GAS VALVE
ASSEMBLY
26. Slide the burner tube back in place and using the screws
removed in step 22 reattach burner tube to the burner
assembly. Securely tighten the two (2) mounting screws.
See Figure 19A or 19B.
assembly. Securely tighten the two (2) mounting screws.
See Figure 19A or 19B.