Maytag MGD7100D Installationsanweisungen

q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Be sure the water faucets are on.

q

  Check for leaks around “Y” connector, faucet, and hoses.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  Check that dryer is level. See “Level Dryer.”

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to 

remove any dust.

q

  Read “Dryer Use” in your Use and Care Guide.

q

  If you live in a hard water area, use of a water softener is    

recommended to control the buildup of scale through the    

water system in the dryer. Over time, the buildup of lime  

scale may clog different parts of the water system, which will  

reduce product performance. Excessive scale buildup may  

lead to the need for certain part replacement or repair.

q

  Plug into a grounded outlet.

q

  Plug into a grounded outlet.

q

  Check that gas supply is on.

q

  Check for leaks.

q

   Check to be sure that the flexible gas line is not crushed  

or kinked.

q

  Select a Timed Dry heated cycle, and start dryer. Do not  

select Air Only Temperature setting.

 

  • Start button has been pressed firmly.
  • Dryer is plugged into an outlet and/or electrical supply is     

   connected.
  • Household fuse is intact and tight, or circuit breaker has   

    not tripped.
  • Dryer door is closed.

This dryer automatically runs an installation diagnostic routine  

at the start of its first cycle.

You may notice an odor when dryer is first heated. This 

odor is common when heating element is first used. The odor will 

go away.

††

 ® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC.

The following instructions are for models with a round and 

square-shaped doors. 

#2 Phillips screwdriver

Min. 8" long TORX T25

® 

††

 

screwdriver

IMPORTANT: If the protective film has not yet been  

removed from the dryer, peel the film from the dryer  

door before proceeding.

Using a TORX T25

®

 screwdriver, remove the 4 screws 

securing the door hinge to the dryer and lift up and out to 

remove the door. Place the door on a soft towel or other  

non-scratch surface. Reinstall the 4 screws in the holes.