Dacor DR30EFS Designanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PG05-008

Revised 11/09/12   Page 4/4

All tolerances +1/16” (+1.6 mm), -0 unless otherwise noted.

 

■

Only models DR30EIS and DR30EIFS may be installed with a raised 

vent. Use only Dacor raised vent model ERV3015.

 

■

A self-rimming countertop configuration is required for raised vent 

installation. On installations with a raised vent, when sliding the range 

into position, it will stop when the rear of the control panel or side 

panels contact the notches toward the front of the countertop.

 

■

The self-rimming installation of the DR30DI range and ERV3015 

raised vent create a “built-in” look where the range trim overlaps the 

countertop on both sides and the raised vent overlaps the countertop 

in back.

* To create a “built-in look” on the front of the cabinet, this dimension may be changed to 29 1/4” (74.3 cm), with the width at the notches remaining 30 

1/16”. This configuration is only for models DR30EIS and DR30EIFS with side panels behind door removed.

Rear wall or

countertop edge

countertop opening

29 1/4” (74.3 cm)

raised vent opening

27 1/2” (69.9 cm)

30 1/16” (76.2 cm)

cabinet opening

below countertop

below countertop

Cabinet face

Notch countertop

to width of cabinets 

3/8” min. (1.0 cm)

 countertop overhang

10” min. (25.4 cm)

to any combustibles 

above counter both sides

19 3/4”

 (50.2 cm)

to

22 3/4”

 (57.8 cm)

19 3/4”

 (50.2 cm)

2 5/8” (6.7 cm)

24 3/8”

 (61.9 cm)

max.

Countertop front

Rear wall or

countertop edge

countertop opening

29 1/4” (74.3 cm)

raised vent opening

27 1/2” (69.9 cm)

30 1/16” (76.2 cm)*

cabinet opening

below countertop

below countertop

Cabinet face

Notch countertop

to width of cabinets 

3/8” min. (1.0 cm)

 countertop overhang

10” min. (25.4 cm)

to any combustibles 

above counter both sides

22 3/4”

 (57.8 cm)

2 5/8” (6.7 cm)

24 3/8”

 (61.9 cm)

max.

Countertop front

Countertop height:  34 3/4” (88.3 cm) min.

 

 

36 7/8” (93.7 cm) max.

Countertop thickness: 1 5/8” (4.1 cm) max.

Cabinet face

Countertop

Range trim resting

on countertop

DR30EI[F]S range

3/8” min. (1.0 cm)

flat countertop

overhang

25 9/16” (64.9 cm)

ERV3015

raised vent

3/8” min. (1.0 cm) space

required behind ERV3015

chassis to clear stiffener

Cabinet face

Countertop

Range trim resting

on countertop

Back of

side panel

rests against

cabinet face 

DR30EI[F]S range

3/8” min. (1.0 cm)

flat countertop

overhang

25 9/16” (64.9 cm)

3 inch

side panel

ERV3015

raised vent

3/8” min. (1.0 cm) space

required behind ERV3015

chassis to clear stiffener