Frigidaire FGIS3065PF Installationsanweisungen

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS

Canada Style

Figure 1

Power Supply Cord Kit (U.S.A.)

The user is responsible for connecting the power

supply cord to the connection block located behind the

back panel access cover.
This appliance may be connected by means of

permanent "hard wiring"; flexible armored or

nonmetallic shielded copper cable (when local code

allow it) or by means of a power supply cord kit.
NOTE: Electric Slide-in Range is shipped from factory

with 1 1/8" (2,9 cm) dia. hole as shown on figure 3. If a

larger hole is required, punch out the knockout.

Risk of fire or electrical shock

exists if an incorrect size range cord kit is used,

the Installation Instructions are not followed, or the

strain relief bracket is discarded.
For mobile homes, new installations or recreational

vehicles, use only a power supply kit designed for a

range at 125V/250V 50A recommended (minimum

40A). Cord must have either 3 (when local code

permits grounding through neutral) or 4 conductors.

Terminal on end of wires must be either closed loop or

open spade lug with upturned ends. Cord must have

strain-relief clamp.

Do not loosen the nuts which

secure the factory-installed range wiring to

terminal block while connecting range. Electrical

failure or loss of electrical connection may occur.

Access to Terminal Block &

Grounding Strap (U.S.A.)

Electrical Shock Hazard

• Electrical ground is required on this appliance.

• Do not connect to the electrical supply until

appliance is permanently grounded.

• Disconnect power to the circuit breaker or fuse

box before making the electrical connection.

• This appliance must be connected to a

grounded, metallic, permanent wiring system,

or a grounding connector should be connected

to the grounding terminal or wire lead on the

appliance.

Failure to do any of the above could result in a

fire, personal injury or electrical shock.

Factory Connected Power

Supply Cord (Canada only)

This range is equipped with a factory-connected power

cord (see Figure 1). Cord must be connected to a

grounded 120/240 volt or 120/208 volt range outlet. If

no outlet is available, have one installed by a qualified

electrician.

This appliance is manufactured

with the frame grounded by connection of a

grounding strap between the neutral power

supply terminal and the frame. If used in USA,

in a new branch circuit installation (1996 NEC),

mobile home or recreational vehicle, where local

code do not permit grounding through neutral

(white) wire or in Canada; remove the grounding

strap from the frame and cut the other end, near

the neutral terminal. Connect the appliance in

usual manner.

Serial Plate Location

You will find the model and serial

number printed on the serial plate.

The serial plate is located as shown.
Remember to record the serial

number for future reference.

Remove the wire cover here

for access to terminal block

Figure 2