Frigidaire FGIS3065PF Installationsanweisungen

7

Where local codes does NOT permit connection of the 

frame grounding conductor to the neutral wire of the 

copper power supply cord (see Figure 4):

1.  Remove the screw which is fixing the rear wire

cover, then remove the rear wire cover (access 

cover) to expose range terminal connection block 

(see Figure 2).

2.  Remove the grounding strap from the terminal 

block and from the appliance frame.

3.  Using the nuts supplied with the literature package, 

connect the ground wire (green) of the copper 

power supply cord to the frame of the appliance with 

the ground screw, using the hole in the frame where 

the ground strap was removed (see Figure 4).

4.  Connect the neutral of the copper power supply 

cord to the center silver-colored terminal of the 

terminal block, and connect the other wires to the 

outer terminals. Match wires and terminals by color 

(red wires connected to the right terminal, black 

wires connected to the left terminal).

5.  Put back the rear wire cover using the screw 

removed on step 1.

Terminal Block

Silver Colored Terminal 

Red

Wire

Neutral 

(White Wire)

Ground (Bare 

Copper Wire)

To 240 V 

Receptacle

A User Supplied 

Strain-relief Must 

Be Installed at 

This Location

Black Wire

1 1/8" (2,9 

cm) Dia. 

Direct 

Connection 

Hole. Punch 

Out Knockout 

for 1 3/8" (3,5 

cm) Dia. Cord 

Kit Hole.

NOTE: Be sure to remove 

the supplied grounding strap.

If local codes permit connection of the frame grounding 

conductor to the neutral wire of the copper power 

supply cord (see Figure 3):

1.  Remove the screw which is fixing the rear wire

cover, then remove the rear wire cover (access 

cover) to expose range terminal connection block 

(see Figure 2).

2.  Using the nuts supplied in the literature package, 

connect the neutral of the copper power supply 

cord to the center silver-colored terminal of the 

terminal block, and connect the other wires to the 

outer terminals. Match wires and terminals by color 

(red wires connected to the right terminal, black 

wires connected to the left terminal) (see figure 3).

3.  Put back the rear wire cover using the screw 

removed on step 1.

Silver Colored Terminal

1 1/8" (2,9 cm) Dia. 

Direct Connection 

Hole. Punch Out 

Knockout for 1 3/8" 

(3,5 cm) Dia. Cord 

Kit Hole.

To 240 V 

Receptacle

A User Supplied 

Strain-relief Must 

Be Installed at This 

Location.

Black 

Wire

Terminal

Block

Neutral 

(White Wire)

Grounding

Strap

Red Wire