BlueStar BWO24AG Installationsanweisungen

                     P/N 750323 Page   17 

 

All specifications are subject to change without prior notification.

 

 



Push in and turn the oven thermostat 
knob counter clockwise to the broil 
“BR” position. 



Properly position the rack and the food 
you will broil to the correct distance 
from the broiler.  



The broiler igniter will begin to glow 
brightly, the gas valve will open to allow 
gas flow and the ceramic burners will 
light.  This takes approximately one min-
ute. 



The infrared oven broiler may have an 
initial bellowing flame that will even out 
to a blanket of blue flame .  After a few 
minutes the ceramic blocks will begin to 
glow brightly and radiate infrared heat. 



Once the broiler reaches proper tempera-
ture it will cycle on and off. 



It is not necessary to pre-heat the broiler 
prior to use. 



The oven burner and broiler will not op-
erate at the same time. 



Do NOT use the convection fan while 
broiling. 

 



Oven comes standard with one full ex-

tension rack per cavity  This allows you 
to pull out the rack 100% from the oven 
cavity for easier loading and unloading of 
large items. 



This rack is originally located on the bot-
tom position of the rack guides. 



This rack can be moved to the other posi-
tions of the rack guides at your conven-
ience. 

      To remove rack : 



This should only be performed when the 
oven is cool and the rack is empty. 



Push the rack fully into the oven. 



Grasp the slides on each side of the rack 
and lift the front up slightly. 



Pull the rack towards you evenly.  There 
is a tab at the rear of each slide positioned 
over and under the rack guide wire. 



Once removed the extension rack can be 
placed at another rack position by revers-
ing the process. 

       To replace rack : 



Grasp the slides on each side of the rack.  
The slides should be fully closed during 
this procedure.  If extended, they can be 
closed by standing the back end of the 
rack on the floor. 



With the rack angled upwards, insert the 
top tab over the rack guide position you 
wish to use.  Tilt down slightly so the bot-
tom tab can be under the wire. 



Push back evenly.  If you do not push 
evenly the slide may bind until you 
straighten it out. 



When the rack is pushed all the way back, 
there is a hook at the front of each slide 
that must go over the front edge of the 
rack guide wire to lock everything into 
position. 

Do not put your face near the infrared broiler 
when lighting.  Keep the door closed during 
lighting and broiling.  Open the door only to 
insert or remove food.