BlueStar BWO24AG Installationsanweisungen

                     P/N 750323 Page   15 

 

All specifications are subject to change without prior notification.

 

 

soapy solution.  DO NOT USE AN 
OPEN FLAME TO CHECK FOR 
LEAKS.  Such a procedure is dangerous 
and it may not detect all the small leaks 
that a soapy solution will. 

16. Air shutter adjustments are preset at the 

factory.  These adjustments may need to 
be redone and/or fine tuned by the in-
staller.  These adjustments are normal.  
They are the responsibility of the quali-
fied installer and are not covered by your 
warranty. 

17. A gas conversion performed in the field 

may void your warranty.  Contact your 
dealer for information regarding the con-
version from one type of gas supply to 
another. 

1.  The installation of this appliance must 

conform with all applicable local codes.  
In the absence of local codes, the installa-
tion must conform to the latest level of the 
National Electric Code, ANSI/NFPA 70. 

2.  This appliance is equipped with a standard 

three prong polarized, NEMA 5-15P line 
cord to be plugged into a 120Volt 15 Amp 
outlet. 

3.  Removing the grounding prong from the 

plug will void the manufacturer’s war-
ranty. 

4.  The cord exits the appliance at the lower 

rear toward the left (viewed from front) 
side. 

5.  If the electrical supply is not turned on or 

is interrupted the appliance will not oper-
ate. 

6.  The applicable wiring diagram for this ap-

pliance is in the Quick Start Package. 

7. The circuit where you plug your appliance 

must be grounded and polarized. 

8.  We recommend the circuit for your appli-

ance be a non-GCFI dedicated line. 

9.  It is recommended that your circuit never 

include a microwave oven. 

This appliance is equipped with a three-
pronged grounding plug for your protec-
tion against shock hazard and should be 
plugged directly into a properly grounded 
receptacle.  Do NOT cut or remove the 
grounding prong from this plug. 
If the appliance is not grounded or its po-
larity is reversed severe shock hazards 
can exist.