Frigidaire FGGF304DPF Installationsanweisungen

10

Level the range by placing a level horizontally on an oven 
rack. Check diagonally from front to back, then level the 
range by adjusting the leveling legs.

LP/Propane gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with 
natural gas.

If you wish to convert your range for use with LP/
Propane gas, use the supplied fixed orifices located 
in a bag containing the literature marked "FOR 
LP/PROPANE GAS CONVERSION." Follow the 
instructions packaged with the orifices for surface, 
oven and broil burners conversion.

The conversion must be performed by a qualified 
service technician in accordance with the 
manufacturer's instructions and all local codes and 
requirements. Failure to follow these instructions 
could result in serious injury or property damage. 
The qualified agency performing this work assumes 
responsibility for the conversion.

 Failure to make the appropriate 

conversion can result in serious personal injury and 
property damage.

Refer to the Use & Care Guide for cleaning 
instructions.
If moving the range is necessary for cleaning or 
maintenance, shut off gas supply. Disconnect the 
gas and electrical supply. If gas or electrical supply is 
inaccessible, lift the unit slightly at the front and pull out 
away from the wall.
Pull only as far as necessary to disconnect the gas and 
electrical supply. Finish moving the unit for servicing 
and cleaning. Reinstall in reverse order making sure to 
level the range and check gas connections for leaks.

before You Call for Service
Read the Before You Call for Service Checklist and 
operating instructions in your 

Use and Care guide. 

It may save you time and expense. The list includes 
common occurrences that are not the result of 
defective workmanship or materials in this appliance.
Refer to your 

Use and Care guide for service phone 

numbers.

The approximate flame length from the burner is 1 inch 
(distinct inner cone of blue flame).
To determine if the broil burner flame is proper, set the 
oven to broil.
If flame is yellow in color, increase air shutter opening 
size (see "2" in Figure 11). If the entire flame is blue, 
reduce the air shutter opening size. 
To adjust, loosen lock screw (see "3" in Figure 11), 
reposition air shutter, and tighten lock screw.
NOTe: bake burners do not have an adjustable air 
shutter.

  The serial plate is located as shown. See the serial 

plate for the following information:

A. Model, lot and serial number of range.
B. Kilowatt rating (power requirements).
C. Voltage ratings.