Frigidaire FGGF304DPF Installationsanweisungen

9

A. Push in and turn each control to LITE until burner ignites.
b.  Push in and quickly turn knob to LOWEST POSITION.
C. If burner goes out, Reset control to OFF. 
d.  Remove the surface burner control knob.
e.  Insert a thin-bladed screwdriver into the hollow valve 

stem and engage the slotted screw inside. Flame size 
can be increased or decreased with the turn of the 
screw.

NOTE: On models with twin burners (two rings of flame), 
only the outer burner is adjustable.

Operation of electric igniters should be checked after 
range and supply line connectors have been carefully 
checked for leaks, and range has been connected to 
electric power. To check for proper lighting:
A.  Push in and turn a surface burner knob to the LITE 

position. You will hear the igniter sparking.

b.  The surface should light when gas is available to 

the top burner. Each burner should light within four 
(4) seconds after air has been purged from supply 
lines. Visually check that burner has lit.

C.  Once the burner lights, the control knob should be 

rotated out of the LITE position.

d.  There are separate ignition devices for each burner. 

Try each knob separately until all burner valves 
have been checked.

Adjust flame until you can quickly turn knob from LITE to 
LOWEST POSITION without extinguishing the flame. Flame 
should be as small as possible without going out.
Note: Air mixture adjustment is not required on surface 
burners.

electric Ignition burners
Operation of electric igniters should be checked after 
range and supply line connectors have been carefully 
checked for leaks, and range has been connected to 
electric power.
The oven burner is equipped with an electric control 
system as well as electric oven and broil burner igniters. 
These control systems require no adjustment. When the 
oven is set to operate, current will flow to the igniter. It will 
"glow" similar to a light bulb. When the igniter has reached 
a temperature sufficient to ignite gas, the electrically 
controlled oven valve will open and flame will appear at the 
oven burner. There is a time lapse from 30 to 60 seconds 
after thermostat is turned ON before the flame appears 
at the oven burner. When the oven reaches the display 
setting, the glowing igniter will go off. The burner flame 
will go "out" in 20 to 30 seconds after igniter goes "OFF". 
To maintain any given oven temperature, this cycle will 
continue as long as the display is set to operate.
After removing all packing materials and literature from 
the oven:
A. Set the lower oven to BAKE at 300°F. See Use & 

Care Guide for operating instructions.

b. Within 60 seconds the oven burner should ignite. 

Check for proper flame, and allow the burners to 
cycle once. Reset controls to OFF.

C. Repeat A and B with the upper oven.
d. Set the upper oven to broil. See Use and Care Guide 

for operating instructions.

e.  Within 60 seconds the broil burner should ignite. 

Check for proper flame. Reset controls to off.