Maytag MEDP475EW Installationsanweisungen

Vent must fit over the exhaust hood. Secure vent to exhaust 

hood with 4" (102 mm) clamp. Run vent to dryer location 

using straightest path possible. Avoid 90° turns. Use clamps 

to seal all joints. Do not use duct tape, screws, or other 

fastening devices that extend into interior of vent to secure 

vent, because they can catch lint.

Using a 4" (102 mm) clamp, connect vent to exhaust outlet  

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

Move dryer to final location. Avoid crushing or kinking vent. 

After dryer is in place, remove corner posts and cardboard 

from under the dryer.

       Not Level 

            

LEVEL                    Not Level

Check levelness of dryer from side to side. Repeat from  

front to back. 

NOTE: The dryer must be level for the moisture sensing  

system to operate correctly.

If dryer is not level, prop up using a wood block, use wrench  

to adjust legs up or down, and check again for levelness. 

Once dryer is level, make sure all four legs are snug against 

the ground before tightening them.