Maytag MEDP475EW Installationsanweisungen

Place towel on top of dryer to avoid damaging the surface.

Lift door until top screws in dryer cabinet are in large part of 

hinge slot. Pull door forward off screws. Set door (handle side 

up) on top of dryer. Remove top screws from dryer cabinet.

Open dryer door. Remove bottom screws from dryer cabinet 

side of hinges. Loosen (do not remove) top screws from dryer 

cabinet side of hinges.

q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  Check that dryer is level. See “Level Dryer”.

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to 

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide.”

q

  Set the dryer on a full heat cycle (not an air cycle) for  

20 minutes and start the dryer.

 

■

Controls are set in a running or “On” position.

 

■

Start button has been pushed firmly.

 

■

Dryer is plugged into an outlet and/or electrical supply  

is on.

 

■

Household fuse is intact and tight, or circuit breaker has 

not tripped.

 

■

Dryer door is closed.

q

  When the dryer has been running for 5 minutes, open the 

dryer door and feel for heat. If you feel heat, cancel cycle and 

close the door.

 

■

There may be 2 household fuses or circuit breakers for 

the dryer. Check that both fuses are intact and tight, or 

that both circuit breakers have not tripped. If there is still 

no heat, contact a qualified technician.

NOTE: You may notice an odor when the dryer is first heated. 

This odor is common when the heating element is first used.  

The odor will go away.

If your door is the 27" Wide Side-Swing Door, go to steps 1–11 

beginning on this page.

If your door is the 27" Wide Side-Swing Door with Glass, go to 

steps 1–13 beginning on page 18. 

NOTE: Magnetized screwdriver is helpful.