Maytag MGDX6STBW Installationsanweisungen

Install exhaust hood and use caulking compound to seal 

exterior wall opening around exhaust hood.

Vent must fit over the exhaust hood. Secure vent to exhaust 

hood with 4" (102 mm) clamp. Run vent to dryer location 

using straightest path possible. Avoid 90° turns. Use clamps 

to seal all joints. Do not use duct tape, screws, or other 

fastening devices that extend into interior of vent to secure 

vent, because they can catch lint.

120 ft. (36.6 m)

110 ft. (33.5 m)

100 ft. (30.5 m)

90 ft. (27.4 m)

80 ft. (24.4 m)

70 ft. (21.3 m)

Turn cold water faucet off and remove washer inlet hose.
Remove old rubber washer from inlet hose and replace  

with new rubber washer. 

For non-steam models, skip to “Connect Vent.”

The dryer must be connected to the cold water faucet using  

the new inlet hoses. Do not use old hoses.

Connect Inlet Hoses  

(Steam Models Only)

Using pliers, tighten the couplings with additional two-thirds  

turn.
NOTE: Do not overtighten. Damage to the coupling can result.

Attach 2 ft (0.6 m) inlet hose to cold water faucet. Screw on 

coupling by hand until it is seated on faucet. Then attach 

“Y” connector to end of the 2 ft (0.6 m) inlet hose. Screw on 

coupling by hand until it is seated on “Y” connector.