Maytag MGDX6STBW Installationsanweisungen

Using a 4" (102 mm) clamp, connect vent to exhaust outlet 

in dryer. If connecting to existing vent, make sure vent is 

clean. Dryer vent must fit over dryer exhaust outlet and inside 

exhaust hood. Check that vent is secured to exhaust hood 

with a 4" (102 mm) clamp.

Move dryer to final location. Avoid crushing or kinking vent. 

Attach dryer 5 ft (1.5 m) inlet hose ends to the “Y” connector. 

Attach washer cold inlet hose to other side of “Y” connector. 

Screw on coupling by hand until it is seated on connector. 

Using pliers, tighten the couplings an additional two-thirds 

turn.
NOTE: Do not overtighten. Damage to the coupling can result.

/

Attach other end of long hose to 

fill valve at top of dryer back panel. 

Screw on coupling by hand until 

it is seated on fill valve connector. 

Using pliers, tighten the coupling 

an additional two-thirds turn.
NOTE: Do not overtighten. Damage 

to the coupling can result.

Check that the water faucet is turned on.

Check for leaks around “Y” connector, faucet, and hoses.