Maytag MGDX6STBW Installationsanweisungen

       Not Level 

            

LEVEL                    Not Level

Check levelness of dryer from side to side. Repeat from  

front to back. 
NOTE: The dryer must be level for the moisture sensing system 

to operate correctly.

If dryer is not level or the same height as the washer, prop up 

using a wood block. Use wrench to adjust legs up or down, 

and check again for levelness. Once legs are level, make sure 

all four legs are snug against the floor before tightening them.

Complete Installation Checklist
q

  Check that all parts are now installed. If there is an extra  

part, go back through steps to see what was skipped.

q

  Check that you have all of your tools.

q

  Dispose of/recycle all packaging materials.

q

  Check dryer’s final location. Be sure vent is not crushed  

or kinked.

q

  Check that dryer is level. See “Level Dryer.”

q

  Remove film on console and any tape remaining on dryer.

q

  Wipe dryer drum interior thoroughly with a damp cloth to 

remove any dust.

q

  Read “Dryer Use” in your “Use and Care Guide.”

q

  Set the dryer on a full heat cycle (not an air cycle) for  

20 minutes and start the dryer.

q

  Be sure the water faucets are on.

q

  Check for leaks around “Y” connector, faucet, and hoses.

q

  If you live in a hard water area, use of a water softener is 

recommended to control the buildup of scale through the 

water system in the dryer. Over time, the buildup of lime 

scale may clog different parts of the water system, which will 

reduce product performance. Excessive scale buildup may 

lead to the need for certain part replacement or repair.

 

■

Dryer is plugged into a grounded 3-prong outlet.

 

■

Electrical supply is connected.

 

■

Household fuse is intact and tight, or circuit breaker has 

not tripped.

 

■

Dryer door is closed.

q

  When the dryer has been running for 5 minutes, open the 

dryer door and feel for heat. If you feel heat, cancel cycle and 

close the door.

If you do not feel heat, turn the dryer off and check to see 

whether gas supply line shut-off valve is open.

 

■

If the gas supply line shut-off valve is closed, open it, 

then repeat the 5-minute test as outlined above.

 

■

If the gas supply line shut-off valve is open, contact a 

qualified technician.

NOTE: You may notice an odor when the dryer is first heated. 

This odor is common when the heating element is first used.  

The odor will go away.