Whirlpool WEC530H0DB Installationsanweisungen

1. Place level on the oven bottom as indicated in one of the two 

figures below depending on the size of the level. Check with 
the level side to side and front to back.

2. If range is not level, use a wrench or pliers to adjust leveling 

legs up or down until the range is level.

NOTE: Range must be level for satisfactory baking 
performance and best cleaning results using AquaLift

®

 

Self-Clean Technology.

If your home has a 3- or 4-wire receptacle, continue with “Install 
Using a Power Supply Cord.” If your home has a 3- or 4-wire 
direct connection, go to “Install Using Direct Wire.”

1. Disconnect power.

2. Remove the lower access cover screws located on the back 

of the range. Pull the bottom of the cover toward you and out 
to remove cover from range. 

3. Remove plastic tag holding three 10-32 hex nuts from the 

middle post of the terminal block.

4. Assemble a UL listed strain relief in the opening.

5. Complete installation following instructions for your type of 

electrical connection:

4-wire (recommended)

3-wire (if 4-wire is not available)

A

B

C

3-wire receptacle
(NEMA type 10-50R)

A UL listed, 
250-volt 
minimum, 
40- or 50-amp, 
range power 
supply cord

3-wire connection: 
Power supply cord

4-wire receptacle
(NEMA type 14-50R)

A UL listed, 
250-volt 
minimum, 
40- or 50-amp, 
range power 
supply cord

4-wire connection: 
Power supply cord

A