Shiro SD2100 Benutzerhandbuch
12
Troubleshooting
Always check first that:
• You have followed the steps listed on pages to install and set up your SD2100.
• All connects are firmly inserted in their sockets.
• All connects are firmly inserted in their sockets.
• Mains power is switched on at the socket.
• The handset’s batteries are correctly and securely installed, and are not run down.
• The handset’s batteries are correctly and securely installed, and are not run down.
If you experience difficulties with the working of your SD2100, refer to the advice given below.
I cannot make or answer calls.
Check that the base unit’s mains power adapter is plugged in and power is switched on. The
Check that the base unit’s mains power adapter is plugged in and power is switched on. The
base unit needs mains power for normal operation of the phone-not just charging the batteries.
Make sure you are using the telephone line cable that was supplied with your SD2100. Other
telephone line cables might not work.
telephone line cables might not work.
Move the handset closer to the base unit.
Check the batteries level symbol on the display. If it is low, replace the handset on the base
unit or charger pod to recharge the batteries.
Switch off power at the mains socket, wait for a few seconds and then switch back on. This may
solve the problem.
solve the problem.
If you still can’t make calls, try re-registering the handset.
When I press keys on the handset, nothing happens.
Make sure the batteries are fitted in your handset. If the batteries level symbol on the display
Make sure the batteries are fitted in your handset. If the batteries level symbol on the display
shows “low”, recharge the batteries.
Check whether there’s a key symbol on the display. If so, the keypad is locked. Turn to the user
manual to find out how to unlock it.
manual to find out how to unlock it.
When I press keys on the handset, digits appear on the display, but I can’t make an outside
call.
Call barring may have been set, see the user manual for more information. Try moving the
Call barring may have been set, see the user manual for more information. Try moving the
handset closer to the base unit. Try a different position for the base unit-perhaps higher, or
further from other electrical equipment.
further from other electrical equipment.
The phone does not ring
Check that the base unit’s mains power adapter is plugged in and power is switched on. The
base unit needs mains power for normal operation of the phone-not just charging the batteries.
base unit needs mains power for normal operation of the phone-not just charging the batteries.
Make sure you are using the telephone line cable that was supplied with your SD2100. Other
telephone line cables might not work.
Check that you have set the ringer volume to off. See the user manual for more information.
Check that you have set the ringer volume to off. See the user manual for more information.
Check that the total REN value of all equipment connected to your telephone line is no more
than 4. Disconnect one or more telephones and see whether that helps.
The base does not ring.
Check that the base power is ON, and the base ringer is set ON.
Check that the line cord is correctly fitted and undamaged.
The CHARGE light on the base unit does not come on."
Check the handset is properly stationed.
Check the handset is properly stationed.
Check the connections between the base unit and mains power socket.
Clean the batteries charging contacts with a dry cloth.
Clean the batteries charging contacts with a dry cloth.
When I press the CALL button, I hear a loud noise.