Shiro SD2100 Benutzerhandbuch

1. Disconnect the power lead from the back of the base unit
2. Press and hold the HANDSET LOCATOR button in the base unit, at the same time

connect the power lead into the back of base unit. Release the LOCATOR button after
you hear “beep” sound for five times. The IN USE light on base unit lights during this

whole process.

3. After 2~3 seconds, you can hear “beep” sound for two times again and the IN USE light

goes off;

4. Disconnect the power lead from base, and then connect it again, you will hear

confirmation tone from the base unit.

Handset registration

Your SD2100 is supplied with the handset already registered to the base unit, and you shouldn't

need to register it. But if you've bought extra handsets separately, you'll need to register each
one to your original base unit. Maximum 4 handsets can be registered to one base.

To register a handset

1. Press and hold the Handset locator button on the base unit for a while, until you hear

"beep" sound twice continuously.

2. Press

the

MENU button, then press UP/DOWN button to the location REGISTER

3. Press

the

OK button, then press UP/DOWN button to the location SUB BASE

4. Press

the

OK button again

5. The display shows BASE? 1 2 3 4. Key in a base unit number
6. The display shows SEARCH + selected number, then shows the ID of the base unit after

3~4 seconds.

7. Press

the

OK button again

8. The display shows PIN?
9. Key in your pin (default 0000) and press OK to confirm.

10. If the display says NOT REG, check to see if you key in the correct PIN, then repeat the

registration procedure again from step 1.

Intercom and transfer

To make an intercom call

1. Press

the

INT button

2. Key in the number of the other handset

On the other handset's display, your number appears, and the INT symbol flashes. Then the

other handset user presses the CALL button to connect the call.
For details of how to change the ringing melody and volume for intercom calls, see "INT

MELODY" and "INT VOLUME" on "HANDSET SETTING" part.

To end an intercom call
Press the CALL button on your handset

The other person will hear Busy tone, and should also press the CALL button to hand up.

To transfer the outside call to another handset (if you have two or more handsets):

• Press the INT button and key in the number of the other handset.

• The outside call is put on hold. When the other handset answers, you can speak to the

user. If the other handset does not answer, you can get back to the outside call by

pressing the INT button again.

To transfer the outside call to another outside phone:

• Press the Recall button and key in the call number you want to transfer.

• The first party is put on hold. When second party answers, you can speak to the user,

then press the CALL button to hang up and transfer the call.

Note : Network Dependant