Toshiba 2051c User Manual

This equipment supports three energy saving modes; the Automatic Energy Save mode, Sleep mode and Super Sleep 

mode. The table below shows the procedures to switch modes manually and the conditions under which the equipment 

enters into or recovers from each mode.

Automatic 
Energy Save 
mode

When a specified period of 
time 

*1

 has passed since the 

last use of the equipment.

—

“Saving energy - press 
START button.” appears on 
the touch panel.

When a button on the 
control panel 

*2

 is pressed 

or when print data or fax 
data are received.

Sleep mode

When the [ENERGY SAVER] 
button 

*3

 is pressed or 

when a specified period of 
time 

*4

 has passed since the 

last use of the equipment.

When a particular option 

*5

 

is installed or when a 
particular protocol 

*6

 is 

enabled.

The touch panel display 
goes off and the [ENERGY 
SAVER] button lights in 
green.

Same as the Automatic 
Energy Save mode.

Super Sleep 
mode

When the [ENERGY SAVER] 
button 

*3

 is pressed or 

when a specified period of 
time 

*4

 has passed since the 

last use of the equipment.

When a particular option 

*5

 

is not installed and also 
when a particular protocol 

*6

 is disabled.

Only the MAIN POWER 
lamp (green) lights.

When the [POWER] button 
is pressed, when print or 
fax data are received 
through a wired LAN or 
when the time set for 
Scheduled Print has come.

*1 

The default value set at the factory shipment is 1 minute.

*2 

Any of the [START], [ENERGY SAVER], [COPY], [e-FILING], [SCAN], [PRINT] and [FAX] buttons.

*3 

[ENERGY SAVER] button on the control panel.

*4 

The default value set at the factory shipment is 1 minute (The default value set at the factory shipment of the European version is 10 minutes).

*5 

The Wireless LAN Module and/or e-BRIDGE ID Gate.

*6 

Any of IPX, AppleTalk and other protocols. When the IPsec function is enabled or the Ethernet speed is set to [AUTO (-1000MB)] or [1000BASE FULL], the 
equipment enters into the Sleep mode. For details, refer to the following guide:

 

&

 TopAccess Guide (PDF): “Chapter 8: [Administration] Tab Page” - “[Setup] Item list”

For changing the set period of time for entering into each mode, refer to the following guide:

&

 MFP Management Guide (PDF): “Chapter 2: SETTING ITEMS (ADMIN)” - “Setting General Functions”

When the set period of time for switching to the Automatic Energy Save mode is the same as that for the Sleep mode or 

the Super Sleep mode, the equipment enters into the Sleep mode or the Super Sleep mode after the set period of time.

For the European version
Contact your service representative to change the default settings noted above.