Sony XCD-SX90CR User Manual
1-4
XCD-U100/SX90/V60
XCD-U100CR/SX90CR/V60CR
1-3-3. DC-DC Converter
1.
Remove the upper case and lower case.
(Refer to Section 1-2-1.)
(Refer to Section 1-2-1.)
2.
Remove the rear panel assembly.
(Refer to Section 1-2-2.)
(Refer to Section 1-2-2.)
3.
Remove the front panel assembly.
(Refer to Section 1-2-3.)
(Refer to Section 1-2-3.)
4.
Remove the FM-96 board. (Refer to Section 1-3-2.)
5.
Disconnect the two flexible flat cables from the
connectors (CN001 and CN002) on the DC-DC
converter.
converter.
6.
Remove the three screws 1, then remove the DC-DC
converter in the direction of the arrow.
converter in the direction of the arrow.
7.
Remove the two screws 2, then remove the board
support.
support.
8.
Attach the DC-DC converter in the reverse order of
steps 1 to 7.
Screws
2
(PM2
x
4)
Screw
1
(PM2
x
4)
Screw
1
(PM2
x
4)
Screw
1
(PM2
x
4)
CN001
CN002
Flexible flat cable
Board support
Flexible flat cable
DC-DC
converter
converter
1-3-4. IF-1068 Board
1.
Remove the upper case and lower case.
(Refer to Section 1-2-1.)
(Refer to Section 1-2-1.)
2.
Remove the rear panel assembly.
(Refer to Section 1-2-2.)
(Refer to Section 1-2-2.)
3.
Remove the front panel assembly.
(Refer to Section 1-2-3.)
(Refer to Section 1-2-3.)
4.
Remove the FM-96 board. (Refer to Section 1-3-2.)
5.
Remove the DC-DC converter.
(Refer to Section 1-3-3.)
6.
Disconnect the three flexible flat cables from the
connectors (CN800, CN801 and CN802) on the IF-
1068 board.
1068 board.
7.
Remove the three screws, then remove the IF-1068
board in the direction of the arrow.
board in the direction of the arrow.
8.
Remove the two shield plates (connector).
9.
Install the IF-1068 board in the reverse order of steps 1
to 8.
to 8.
PM2
x
4
CN800
CN801
CN802
Flexible flat cable
Flexible flat cable
Flexible flat cable
Shield plates
(connector)
(connector)
IF-1068 board