Sony XCD-SX90CR User Manual

1-3

XCD-U100/SX90/V60

XCD-U100CR/SX90CR/V60CR

1.

Remove the upper case and lower case.
(Refer to Section 1-2-1.)

2.

Remove the front panel assembly.
(Refer to Section 1-2-3.)

3.

Remove the two screws.

4.

Remove the solders of CCD, then remove the BI-217/

218/219 board.
. BI-217 board: 16 solders
. BI-218 board: 24 solders
. BI-219 board: 20 solders

5.

Install the BI-217/218/219 board in the order of steps

3, 4, 2 and 1.

Front panel assembly

CCD

PM2 

x

 4

Solders

This illustration is for XCD-V60/V60CR.

BI-217/218/219 board

n
When replacing the FM-96 board, perform the writing of

the serial number and Node Unique ID. For details, refer to
Section 2-1.

1.

Remove the upper case and lower case.

(Refer to Section 1-2-1.)

2.

Remove the rear panel assembly.

(Refer to Section 1-2-2.)

3.

Remove the front panel assembly.

(Refer to Section 1-2-3.)

4.

Disconnect the three flexible flat cables from the

connectors (CN200, CN400 and CN700) on the FM-96
board.

5.

XCD-SX90/SX90CR:
Remove the three screws, then remove the shield sheet

and FM-96 board.
XCD-V60/V60CR/U100/U100CR:

Remove the three screws, then remove the FM-96
board.

6.

Install the FM-96 board in the reverse order of steps 1
to 5.

PM2 

x

 4

CN200

CN700

XCD-SX90/SX90CR

CN400

Flexible flat 
cables

Shield sheet

Flexible flat cable

FM-96 board