Panasonic DMW-MCTZ3 User Manual
21
VQT1F25
4
Remove the O-ring from the Case and check that there is no debris,
etc. in the O-ring groove.
etc. in the O-ring groove.
5
Check that there are no scratches etc. on the O-ring while you are
applying the grease.
applying the grease.
∫ Notes
Be careful when removing the digital camera from the Case so that it
does not get wet.
≥
Be careful when removing the digital camera from the Case so that it
does not get wet.
≥
Remove the camera with clean hands. (Wash your hands with fresh water and then
thoroughly dry them.)
thoroughly dry them.)
≥
Thoroughly dry any moisture on your body or hair. (Be particularly careful about any
water coming from the sleeves of your thermal suit.)
water coming from the sleeves of your thermal suit.)
≥
When the weather or the sea is particularly bad, select a place where the digital
camera will not get wet e.g. indoors or where there is a roof overhead.
camera will not get wet e.g. indoors or where there is a roof overhead.
Cleaning and Storing
1
Wash the outside of the Case with water.
≥
≥
Wash the outside of the Case until it is clean. (P20)
≥
Be sure to close the Case and then wash the outside with only water.
≥
Wipe off any dirt inside the Case with a wet, soft cloth.
∫ Notes
≥
≥
Do not wash the Case with pressurized water as it may cause water leakage.
Remove the digital camera before washing the Case with water.
Remove the digital camera before washing the Case with water.
≥
Do not leave the digital camera inside the Case when storing it.
≥
Store the Case in a cool, well-ventilated place.
Caution for Use
∫
Handling of the O-ring
≥
Do not use alcohol, thinner or a chemical cleaning agent for cleaning the O-
ring. This will cause damage to, or deterioration of, the O-ring.
ring. This will cause damage to, or deterioration of, the O-ring.
≥
If you will not be using the Case for a long period of time, remove the O-ring
from the O-ring groove, apply a thin coat of grease (supplied), place it in a
clean polyester bag and then store it in a cool, dark place to prevent the
surface from being damaged. When you use the O-ring again, thoroughly
check that it is not scratched or split.
from the O-ring groove, apply a thin coat of grease (supplied), place it in a
clean polyester bag and then store it in a cool, dark place to prevent the
surface from being damaged. When you use the O-ring again, thoroughly
check that it is not scratched or split.
DMW-MCTZ3.book 21 ページ ２００７年２月６日 火曜日 午後１時２１分