Panasonic KX-TG9391 User Manual
Useful Information
47
For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
Busy
L
The called handset or base unit is in use.
L
Other units are in use and the system is busy. Try again later.
L
Privacy mode is on for the call you tried to join (page 21).
L
The handset you are using is too far from the base unit. Move closer
and try again.
and try again.
L
The handset’s registration may have been canceled. Re-register the
handset (page 32).
handset (page 32).
Check tel line 1
Check tel line 2
L
The supplied telephone line cord has not been connected yet or not
connected properly. Check the connections (page 13).
connected properly. Check the connections (page 13).
L
If you use the unit as a single-line telephone only, erase the message
as follows:
as follows:
To erase “Check tel line 1”, press {MENU}. i
{#}{
{#}{
1}{8}{9}
To erase “Check tel line 2”, press {MENU}. i
{#}{
{#}{
1}{9}{0}
When a power failure occurs, the message is displayed again. Erase
again as above.
again as above.
Error!!
L
The handset’s registration has failed. Move the base unit and
handset away from all electrical appliances and try again.
handset away from all electrical appliances and try again.
L
Recording was too short. Try again.
Failed
L
Phonebook copy failed (page 24). Confirm the other unit (the
receiver) is in standby mode and try again.
receiver) is in standby mode and try again.
Incomplete
L
Phonebook copy is incomplete. The receiver’s phonebook memory
is full. Erase the unnecessary phonebook entries (page 23) from the
other unit (the receiver) and try again.
is full. Erase the unnecessary phonebook entries (page 23) from the
other unit (the receiver) and try again.
Memory full
L
The phonebook memory is full. Erase unnecessary entries (page
23).
23).
L
Message memory is full. Erase unnecessary messages (page 37,
38).
38).
Messages full
L
Message memory is full. Erase unnecessary messages (page 37,
38).
38).
No link to base.
Reconnect AC adaptor.
L
The handset has lost communication with the base unit. Move closer
to the base unit and try again.
to the base unit and try again.
L
Unplug the base unit’s AC adaptor to reset the unit. Reconnect the
adaptor and try again.
adaptor and try again.
L
The handset’s registration may have been canceled. Re-register the
handset (page 32).
handset (page 32).
Use rechargeable
battery.
L
A wrong type of batteries such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on page
4, 15.
inserted. Use only the rechargeable Ni-MH batteries noted on page
4, 15.
You must first
subscribe to Caller
ID.
L
You must subscribe to Caller ID service. Once you receive caller
information after subscribing to Caller ID service, this message will
not be displayed.
information after subscribing to Caller ID service, this message will
not be displayed.
TG9391.book Page 47 Tuesday, July 8, 2008 8:01 AM