ICOM IC-706MKIIG User Manual

44

5

MEMORY AND SCAN OPERATION

➀

Select VFO mode, then set a frequency.

➁

Close the squelch with [SQL].

➂

Set the desired memory channel as the watching
channel.

➃

Select S2, then push [

(F-2)

PRI] to start the watch.

• Decimal point blinks while scanning.

➄

When the scan detects a signal, the scan pauses
for 10 sec. or until the signal disappears, depend-
ing on the resume setting.

➅

To cancel the scan push [

(F-2)

PRI].

Note: The paused condition when detecting a signal
differs depending on the scan resume condition.
resume on: pauses for 10 sec.
resume off: pauses until the signal disappears.

➀

Select memory mode.

➁

Close the squelch with [SQL].

➂

Select S2, then push [

(F-1)

SCN] to start the mem-

ory scan.

• Decimal point blinks while scanning.

➃

Push [

(F-2)

SEL] to change the memory scan to

select memory scan.

• Push [

(F-2)

SEL] for 2 sec. to clear all select memory

channels.

➄

When the scan detects a signal, the scan stops or
pauses depending on the resume setting.

➅

To cancel the scan push [

(F-1)

SCN].

Note: Two or more memory channels must be desig-
nated as select memory channels for select memory
scan to start.

S2 SCN SEL V/M

Select
memory mode

Designate
“S.”

Push [

(F-1)

SCN], then [

(F-2)

SEL].

➀

Select memory mode.

➁

Close the squelch with [SQL].

➂

Select S2, then push [

(F-1)

SCN] to start the scan.

• Decimal point blinks while scanning.

➃

When the scan detects a signal, the scan stops or
pauses depending on the resume setting.

➄

To cancel the scan push [

(F-1)

SCN].

Note: Two or more memory channels must be pro-
grammed for memory scan to start.

S2 SCN SEL V/M

Select
memory mode

then push [

(F-1)

SCN]

➀

Select VFO mode.

➁

Select the desired operating mode.

• The operating mode can also be changed while scan-

ning.

➂

Set [SQL] open or closed.

• See page a left for squelch condition.

➃

Select S2, then push [

(F-1)

SCN] to start the scan.

• Decimal point blinks while scanning.

➄

When the scan detects a signal, the scan turns
OFF, pauses or ignores it depending on the
resume setting and the squelch condition.

• During scan [TS] can be used only when resume is ON.

➅

To cancel the scan push [

(F-1)

SCN].

Note: If the same frequencies are programmed into
the scan edge memory channels 1A and 1B, pro-
grammed scan does not start.

■ Programmed scan operation

■ Memory scan operation

■ Select memory scan operation

S2 SCN PRI V/M

Select
VFO mode

Select watching
channel

Push [

(F-2)

PRI].

■ Priority watch

S2 SCN PRI V/M

Select
VFO mode

then push [

(F-1)

SCN]