Avaya 03-300430 User Manual

1032

ABRT

The EI cannot detect the framing signal and cannot run the test.

1. Refer to the errors for Test #238 to determine why the EI circuit pack is 

out of frame.

1033

ABRT

The EI circuit pack does not have a fiber link administered to it. There is 
not sufficient data to run test.

1. Use list fiber-link to verify that there is no fiber link 

administered to this circuit pack.

2. If there is no fiber administered to this circuit pack, but there should 

be, use add fiber-link to add the correct fiber.

3. Retry the command.

1394

ABRT

The EI circuit pack is out of service and the test cannot be run. This 
condition is due to a change in the EI circuit pack’s ability to communicate 
with the EI or SNI circuit pack on the other end of the fiber.

1. Run Test #237, and check the Error Log for EXP-INTF error type 

1281. If error type 1281 is present or if Test #237 does not pass, see 
repair procedures for Test #237, in 

1395

ABRT

This test cannot be run on an EI circuit pack if it is part of the B-side PNC 
and duplicated PNC is not enabled.

1. If this test needs to run on this EI circuit pack, use change 

system-parameters duplication to enable PNC.

2. Use set pnc lock to prevent the system from doing a PNC 

interchange.

3. Repeat this test.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

 3 of 4