Avaya 03-300430 User Manual

This test is nondestructive.
This test is a request to an EI circuit pack to determine whether it is currently detecting the 
framing sequence on the incoming fiber’s data stream. If it cannot detect this framing signal, the 
EI circuit pack will not be able to establish a link with the opposite EI or SNI circuit pack.
For EI-to-EI fiber links, this test is run on both EI circuit pack endpoints of the fiber link.

ABRT

Internal system error (software).

1. Run test board location separately for each EI endpoint on this 

fiber link and follow the procedures for this test in the 

on page 1176 section of the 

maintenance manual.

2. If the test continues to abort or fail, escalate the problem.

1033

ABRT

The EI circuit pack does not have a fiber link administered to it. There is not 

sufficient data to run test. Because test fiber-link was run, the 

expansion interface should be administered on a fiber link, therefore this 

must be a software problem.

2000

ABRT

Response to the test request was not received within the allowable time 
period.

1. Run test board location separately for each EI endpoint on this 

fiber link and follow the procedures in 

2100

ABRT

System resources required to run this test are not available.

1. Run test board location separately for each EI endpoint on this 

fiber link and follow the procedures in 

2500

ABRT

Internal system error

1. Run test board location separately for each EI endpoint on this 

fiber link and follow the procedures in 

 1 of 2