Avaya 03-300430 User Manual

This test is nondestructive.
This test checks the status of the C-LAN Ethernet port that is the near end gatekeeper this 
signaling group. If the C-LAN Ethernet port is in service, the test passes; if it is OOS (out of 
service), the test fails.

Note:

Failure of this test will put the SIG-GRP in the OOS state.

1125

ABRT

Ethernet Link is not in service.

1. Check if the Ethernet link is in service or not. If the link is not in service, 

release the link using release link n or release port 
location, and repeat the test. This is a normal abort.

2. If the test continues to abort after following the repair procedures, 

escalate the problem.

2000

ABRT

Response to the test was not received from the TN799DP C-LAN circuit 
pack within the allowable time period.

1. If this result occurs repeatedly, attempt to reset the circuit pack if the 

other ports on the board are idle (amber LED is off). Reset the circuit 
pack by issuing busyout board location, reset board 
location, and release board location.

2. If this result occurs again, replace the circuit pack.

2100

ABRT

The necessary system resources to execute the test could not be 
allocated.

1. Retry the command at 1-minute intervals up to 5 times.

2500

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 3 times.

FAIL

The C-LAN Ethernet port corresponding to the near-end address of the 
SIG-GRP that is OOS has failed. Every session is down.

1. Execute test port location long and verify the result of the 

H.323 Signaling Group Ping test (#1387). If the test continues to fail, 
escalate the problem. If the test passes wait for the sessions to come 
up.

 1 of 2