Avaya 03-300430 User Manual

7

ABRT

Destination unreachable.

1. Verify that the C-LAN has been administered with an IP-Route that 

enables the C-LAN to reach the far-end IP address.

2. Once verified, use test sig-group grp# to verify that the H.323 

Signaling Group Ping test (#1387) passes.

1005

ABRT

Configuration for this test is incorrect.

1. Verity that the link is in service with the status port or status 

link. Verify that the routing table has destinations that are reachable 

through this port.

2. Repeat the test.

3. If the test aborts with Error Code 7, while step 1 verified, escalate the 

problem.

1125

ABRT

 Link is not in service.

1. Check if the link is in service or not. If the link is not in service, release 

the link using release link or release port, and repeat the test. 

This is a normal abort.

2. If the test continues to abort after following the repair procedures, 

escalate the problem.

2000

ABRT

Response to the test was not received from the C-LAN circuit pack within 
the allowable time period.

1. If this result occurs repeatedly, attempt to reset the circuit pack if the 

other ports on the board are idle (amber LED is off). Reset the circuit 
pack by issuing busyout board location, reset board 
location, and release board location.

2. If this result occurs again, replace the circuit pack.

2012

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

The necessary system resources to execute the test could not be 
allocated.

1. Retry the command at 1-minute intervals up to 5 times.

 2 of 3