Avaya 03-300430 User Manual

resources associated with every DSP out of service, and then attempt to reset the TSI. For 
the repair procedure, see associated Test #1406.

j. Error Type 1538: this error indicates hyperactivity on the board. Hyperactivity means the 

circuit pack is sending too many uplink messages to switch software. The circuit pack will be 
taken out of service. See Error Type 3999.

k. Error Type 1793: this error indicates a loss of the Network Interface Connectivity. Either the 

Ethernet cable is unplugged, there is a problem with a connection, or there is a problem with 
the network.

l. Error Type 2049: the processor, specifically the Power PC, 860T hardware is failing. The 

PPC provides the Angle functionality as well as the UDP/IP interface; an attempt is made to 
reset the board automatically. For the repair procedure, see associated Test #1406. If the 
reset fails, the board is probably bad and should be replaced.

m. Error Type 2305: IP address inconsistency between switch software and the IPMEDPRO 

board. If this error occurs, an attempt will be made to download the IP address again. If the 
board still refuses the IP address, the board will be reset. See associated test #1371. 

n. Error Type 2561: the ping test has failed. For the repair procedure, see the associated test 

#1379.

o. Error Type 2817: indicates an Ethernet hardware failure on the TN2302 circuit pack. The 

switch will take resources associated with every DSP out of service and then attempt to 
reset the Ethernet hardware. There are several error conditions that can be sent up in the 
error message for this problem; they will be treated as the same failure by switch software. 
For the repair procedure, see associated Test #1405.

p. Error Type 3073: circuit board reset failed. The switch will take resources associated with 

every DSP out of service and then attempt to reset the board, as the failure of a Scotch is 
severe enough to warrant a board reset. After the reset a query is made again for the health 
of the Scotch devices to verify whether they are working properly or not. If they are working 
properly, the alarm and error counters are cleared; if they are not working properly the alarm 
will continue, every DSP will be left out of service, and maintenance diagnostics will stop. If 
the board continues to fail with this error type, replace the TN2302. 

q. Error Type 3329: an IP address update (Test #1371) was sent to the circuit pack, which 

detected that this IP address is a duplicate of an existing network IP address. Duplicate IP 
addresses can cause problems with terminations on the IPMEDPRO circuit pack. There is 
no way to place indications of where the other duplicate address is located. See the repair 
procedure for test #1371.

r. Error Type 3585:

Aux Data = 1: The NIC parameters on the board do not match those in administration. 
Software is trying to negotiate the settings on the circuit pack to match the administered 
settings. See the repair procedures for test #1511. 

Aux Data = 2: The board is reporting different options than what is administered. Software 
tried to correct the options, but the board did not take the option update. See the repair 
procedures for test #1511.