Avaya 03-300430 User Manual

This test is destructive.

Note:

This test aborts with Error Code 1412 on the G700 Media Gateway.

This test verifies the connectivity of an ISDN-PRI signaling port (D channel) across the packet 
bus, also known as the LAN bus. It will execute only if the port is out of service. Failure of this 
test indicates a fault associated with the port hardware on the circuit pack.

1700

ABRT

Rollabout video abort. The PRI terminal adapter associated with this 
D-channel port is detached from the circuit pack. This is normal when the 
rollabout video feature is enabled. To complete a test on this port:

1. Re-attach the disconnected PRI terminal adapter.

2. Enter change ds1 location to disable rollabout video on the 

board, and set the “Alarm when PRI Endpoint Detached” field to y.

8

FAIL

The UDS1 TN464C/D, TN464F/GP circuit pack is not in service.

1. Check the Hardware Error Log for entries logged against UDS1-BD, 

and consult “UDS1-BD” for repair procedures.

PASS

The UDS1 Interface circuit pack transporting the ISDN-PRI Signaling Link 

Port is in service.

Any

The test could not relate the internal ID to the port (no board). This could be 

due to incorrect translations, no board is inserted, an incorrect board is 

inserted, or an insane board is inserted.
Ensure that the board translations are correct. Execute add ds1 

location to administer the MM710 interface if it is not already 

administered.
If the board was already administered correctly, check the error log to 

determine whether the board is hyperactive. If this is the case, the board is 

shut down. Reseating the board will re-initialize the board.
If the board was found to be correctly inserted in step 1, then enter 

busyout board location.

Enter reset board location.

Enter release board location.

Enter test board location long.

This should re-establish the linkage between the internal ID and the port.

 2 of 2