Avaya 03-300430 User Manual

This test is destructive.
This test resets the circuit pack. The test is highly destructive and can only be initiated by a 
system technician-demanded reset board location.

None

ABRT

System resources required for this test are not available.

1. Retry reset board at 1-minute intervals up to 5 times.

1015

ABRT

Port is not out-of-service.

1. Busyout the circuit pack (busyout board location).
2. Execute reset board.

2100

ABRT

System resources required for this test are not available.

1. Retry reset board at 1-minute intervals up to 5 times.

1

FAIL

The circuit pack failed to reset.

2

FAIL

The circuit pack failed to restart.

1. Execute reset board.
2. If the problem persists, replace the circuit pack.

PASS

The circuit pack initializes correctly.

1. Run the short test sequence.

0

NO

BOARD

The test could not relate the internal ID to the port (no board). This could 
be due to incorrect translations, no board is inserted, an incorrect board 
is inserted, or an insane board is inserted.

1. Ensure that the board translations are correct. Use add ds1 

location to administer the MAPD interface if it is not already 

administered.

2. If the board was already administered correctly, check the error log 

to determine whether the board is hyperactive. If so, the board was 
shut down. Reseating the board re-initializes it.

3. If the board was inserted correctly, enter busyout board.
4. Enter the reset board command.
5. Enter the release board command.
6. Enter the test board long command.

This should re-establish the linkage between the internal ID and the port.