Avaya 03-300430 User Manual

f. Error Type 515: For the TN802B only, this error type indicates that every DSP is OOS (out 

of service), and a MINOR alarm is raised. The Aux Data field contains the number of DSPs 
that are OOS.

g. Error Type 1025: The port is OOS (out of service) because of a board-level failure. Check 

for errors/alarms against the board, in particular ping problems, IP address inconsistency, or 
board sanity problems.

1. Verify correct administration.

2. Check cabling and customer network before replacing circuit pack.

Investigate tests in the order presented below. Clearing Error Codes associated with the one 
test may also clear errors generated from other tests in the sequence.

This test is nondestructive.

When using theTN802B, this test polls the circuit pack for the number of failed DSPs. If every 
DSP is functional, the test passes and the board is operating at maximum capacity. If any DSPs 
have failed, the test fails and reports the number of failed DSPs.
A failure of 3 or fewer DSPs does not result in an alarm. A failure of more than 3 and up to 8 
DSPs results in a warning alarm. A failure of more than 8 DSPs results in a minor alarm. In all 
cases, except when every DSP fails, the MEDPROPT continues to provide reduced capacity.

1. D = Destructive; ND = Nondestructive

DSP Query test (#1382)

X

X

ND

TDM NIC Loop-Around test (#1380)

X

X

ND

Port Status test (#1407)

X

X

ND