Avaya 03-300430 User Manual

When using the TN2302 or TN2602, this test polls the circuit pack for the state of health of a 
specific DSP. If the DSP is bad, an error will be logged and the board will be polled again. If the 
circuit pack is still failing, the DSP will be taken out of service and a MINOR alarm will be raised.

1014

ABRT

Board not inserted.

1022

ABRT

Board not valid for test.

2000

ABRT

Response to the test was not received within the allowable time period.

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error

1. Retry the command at 1-minute intervals up to 3 times.

1–11

FAIL

Some DSPs on the circuit pack have failed. The FAIL code is the number of 

bad DSPs reported (TN802B only).

FAIL

For the TN2302 and TN2602 only, the DSP failed. If it continues to fail, it 

will be taken out of service.

PASS

All 11 DSPs are functioning and in-service.

0

NO

BOARD

No board was detected by the test.

1. Check the Error Log for wrong board (Error Type 125) or no board 

(Error Type 131). Resolve either of these issues, if applicable.

2. Check that the board is properly translated and inserted. If so, check 

for hyperactivity. If hyperactive, use reset board location.

3. Run the test again. If it fails, the circuit pack may be bad. Replace the 

circuit pack and retest.