Avaya 03-300430 User Manual

This test is nondestructive.
This test queries the state of the DSP port.

1

ABRT

This port is Out of service (OOS) due to:

●

A board-level problem, for example no IP address has been 
translated for this location.

●

A DSP hardware problem (see 

on page 1557 and 

page 1555). 

2

ABRT

This port has been made maintenance busy.

1002

ABRT

The system could not allocate timeslots for the test. The system may be 
under heavy traffic conditions, or it may have timeslots out of service 
due to TDM-BUS errors.

1. If the system has no TDM-BUS errors and is not handling heavy 

traffic, retry the command at 1-minute intervals up to 3 times.

2. If the system has TDM-BUS errors, clear any errors, and retry the 

command at 1-minute intervals up to 3 times.

3. If the command continues to abort, escalate the problem.

2000

ABRT

 Response to the test was not received in the allowable time period.

1. Retry the command at 1-minute intervals up to 3 times.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals up to 3 times.

2500

ABRT

Internal system error.

1. Retry the command at 1-minute intervals up to 3 times.

FAIL

Unable to get status for this port. Verify that this board has been 

administered correctly, and that there are no alarms against this board.

PASS

The board is functioning properly and the port is in-service and available.

0

NO

BOARD

No board was detected by the test.

1. Resolve either wrong board (Error 125) or no board (Error 131) 

issues, if applicable.

2. Check that the board is properly translated and inserted. If so, check 

for hyperactivity (Error 1538). If hyperactive, use reset board 
location.

3. Run the test again. If it fails, replace the board and retest.