Avaya 03-300430 User Manual

2000

ABRT

Response to the test was not received within the allowable time period. 

This may be due to hyperactivity. Error Type 1538 in the error log 

indicates hyperactivity. The hyperactive Media Module is out of service 

and one or more of the following symptoms may be exhibited:

●

The MG-DS1 tests (such as Test #138 and Test #139) are aborting 
with Error Code 2000.

●

The tests run on the ports of this Media Module are returning a no 
board result.

●

A busyout or a release command has no affect on the test 

results.

●

A list config command shows that the Media Module and the 

ports are properly installed.

When hyperactivity occurs, the Media Module is isolated from the 
system, and all of the trunks for this Media Module are placed into the 
out of service state. The system will try to restore the Media Module 
within 15 minutes. When no faults are detected for 15 minutes, the 
MM710 interface Media Module is restored to normal operation. All of 
the trunks for the Media Module are then returned to the in service state. 
Hyperactivity is often caused by the associated facility. In such a case, 
faults (such as slips, misframes, or blue alarms) would be entered in the 
error log. In addition, many hardware errors would be logged against the 
associated trunk circuits. 

1. If the facility is OK and the error occurs again after 15 minutes, 

replace the Media Module.

2100

ABRT

Could not allocate the necessary system resources to run this test.

1. Retry the command at 1-minute intervals for a maximum of 5 times.

 2 of 4