Avaya 03-300430 User Manual

c. Error Type 18: the circuit pack has been busied out by the command busyout board 

location. Execute release board location.

d. Error Type 36: a port processor on the circuit pack failed to initialize. Reset the circuit pack 

using busyout board location, reset board location, and release board 
location. If the problem does not go away, replace the circuit pack.

e. Error Type 257: a Control Channel Protocol error has occurred. This may be due to the 

circuit pack detecting an on-board hardware failure. Execute busyout board location 

and reset board location to reset the circuit pack. Any such problem will be detected 

during initialization, because the circuit pack locks up and appears insane to the system.

f. Error Type 217, 267: an extra TN771D circuit pack has been inserted into the port network.

g. Error Type 513: an on-board hardware failure has been detected by the circuit pack. Enter 

the busyout board location, reset board location, and release board 
location commands to reset the circuit pack. If the SAKI Sanity test (#53) passes, the 

circuitry is healthy. If not, replace the circuit pack.

h. Error Type 769: program logic error; no action is required. This error may lead to errors of 

other types being reported against this circuit pack.

i. Error Type 1025: the circuit pack cannot update NPE memory and read it back. This error 

type can be ignored, but might lead to errors of other types being reported against this 
circuit pack.

j. Error Type 1538: excessive number of messages have been received from the 

Maintenance/Test circuit pack. This may be due to a hardware problem on the circuit pack. 
The switch takes the board out of service and periodically puts it back into service to see if 
the problem has disappeared. If the problem persists, replace the circuit pack.

k. Error Type 3840: the circuit pack received a bad control channel message from the switch. 

This error is not service affecting and no action is required.

l. Error Type 3999: the circuit pack sent a large number of control channel messages to the 

switch within a short period of time. If Error Type 1538 is also present, then the circuit pack 
was taken out-of-service due to hyperactivity. If Error Type 1538 is absent, then the circuit 
pack was not taken out-of-service, but it has generated 50% of the messages necessary to 
be considered hyperactive. This may be completely normal during heavy traffic periods. 
However, if this error type is logged when the circuit pack is being lightly used, it may 
indicate a problem with the circuit pack or the equipment attached to it.